Concrete Washout Bag 1750 x 1040 x 370mm — 2470kg Load Tested | AS 3668 Forklift Loops

A designated washout point in one bag. Set it beside the pour, wash the chute, hopper, pump line or tools down into it, and the slurry stays in the bag instead of running into soil, gutters or stormwater. The bag holds approximately 0.67 m³ (around 670 litres), is load tested to 2470kg and complies with AS 3668. Four lifting loops let a forklift or crane move it wet or cured. Stocked at Wetherill Park for same-day Click & Collect and fast dispatch Australia-wide.

Where it's used

• Concrete truck washout point on site erosion and sediment control plans (ESCPs)
• Pump and line washout after a pour
• Shotcrete crews, kibbles and wheelbarrow rinse-down
• Demolition and cutting slurry containment
• Any site where council or EPA conditions require a contained washout area and no discharge to stormwater

What you get

• 1 x Concrete Washout Bag, 1750mm x 1040mm x 370mm, SKU CWOB_000
• Folds flat for storage in the site container until needed
• No frame, fixings or bunding required

How to use it

• Place on level ground close to the pour or pump set-up
• Open the top and wash down directly into the bag
• When full, either lift out by the loops and dispose of as inert waste, or leave the contents to cure and forklift out as a solid block for use as ballast, fill or compound edging
• Do not lift a loaded bag by hand

Before you order

• There is no drain. Contents must either set in the bag or be lifted out wet.
• Check your forklift or crane capacity against a full bag. Concrete slurry is roughly 2.4 tonnes per cubic metre, so a full bag can approach 1.6 tonnes.
• Need more than a few? Contact us for carton pricing.

Related products

• Concrete Accessories — bar chairs, tie wire, expansion foam
• Silt Protection — silt fence and sediment control
• Flat Drain Guard 1100 x 1100mm — protect the nearest stormwater pit
• Stormwater Drain Seal
• Builders Plastic Film 200um — ground sheet under the washout area